I wanted to mount my USB hub from Anker somewhere on my monitor (msi optix mag342cqr) and then I remember I had some built in slots that MSI uses to hang a mouse bungee on the monitor. So I measured and modelled a simple mounting case for my USB hub that slides into these existing slots. The result is a sleek solution so I can quickly plug and unplug my USB drives :)

Print should not require any support with my printing profile.

To combine the 2 parts I modelled some holes that seat two 3.5x16MM screws which I had on hand.

I'm still relatively new to Fusion360 so there might be some flaws but it prints and fits nicely :)