Blastoise Multipart 50% all parts x3 Remixed by PRINT3DGIFTS

Remixed by

PRINT3DGIFTS

Art>Sculptures

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.16mm layer, 3 walls, 10% infill

Designer

9 h

8 plates

4.5(6)

Open in Bambu Studio

Boost

143

Released

Description

Scaled all parts down to 50%.
All plates have 3x parts to end up with 3 blastoises :)
I updated the 3mf file because the black parts didn't scale at 50% not sure why.

Comment & Rating (12)

@Dripster

Boosted

Nice multipart print. Printed very well! Only "issue" was the "inside leg" files which printed like shown in the last picture. I think this is due to the small scale. As soon as i scale the model lager, it shows the parts correctly and will certainly print them correctly. However, this did not prevent the perfect assembly and is not visible in the finished model. Thanks for this awesome Blastoise model 👍🏻

(Edited)

The designer has replied

@PRINT3DGIFTS

yeah you are correct. scaled down to less then 50% was not really working for me so i made it at 50%.. i also have a scaled up version up to 600% but i didn't start printing it😂 not enough filament atm and i had to cut all existing parts again into pieces and it exceeded the max amount of plates in bambustudio😂

@Aleandrus

Boosted

Print Profile

0.16mm layer, 3 walls, 10% infill

Love it! =) It works a bit like a puzzle, with all the parts that needs to be put together to obtain the full figure. Already printed a full team of 6 Blastoise to go fight and win the Pokémon League! Thank you very much for sharing this nice model with little to none wasted filament(except the eyes, but very little).

@Viiitek

Print Profile

0.16mm layer, 3 walls, 10% infill

(Edited)

Bed Adhesion Issue:Leider total keine Haftung, trotz sauberen Bett usw. Und wieso werden 6 Stück gedruck? Turtok hat doch nur zwei Kanonen…

The designer has replied

@PRINT3DGIFTS

clean your bed again ;). sorry but all adhesive fails i cannot say more about it.. flip your bed to the other side of use hairspray. i never had to use it but i also don't clean my bed with isoprop alcohol

@Viiitek

Replying to @PRINT3DGIFTS :

Why are there 6 cannons? Turtok only needs 2. I'm not a beginner. My bed is always rubbed with dishwashing liquid and washed with warm water and I never have any problems with any of my prints.

@PRINT3DGIFTS

Replying to @Viiitek :

for if one of his cannons not work🤣 everything is in triple, not only the cannons. it's because i'm not a fan of only using a small part of the printbed when i'm away all day :) that's why it's in multiple canons but you can delete the amount of part you don't need. for me it just saves good amount of time and i always have some spare parts at hand if something should went wrong with some parts during printing.