Gridfinity Hex Driver Tray
Copyright Claim
Gridfinity Hex Driver Tray
Boost
33
83
14
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
3.2 h
1 plate
Open in Bambu Studio
Boost
33
83
14
2
110
66
Released
Description
Designed to work with the amazing organization system from the mind of Zack Freedman! I present yet another Gridfinity tray… this time for the hex drivers!
Comment & Rating (14)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
doesn't work with the little caps on the end of the driver's, but it works great other wise. so still lgets 5 starts.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
I am so sad about this print. I printed it out, and it's just a few mm too short for each one to fit.
1
Reply
al you have to do is shorten the driver...hex screw loosen and shorten the length.
0
Reply
Replying to @mrhansen7692
Nope, thats not the solution. Grip is too long to fit. Works if you remove the cap, making them looking ugly.
0
Reply
3mm too short for the screw drivers with cap
Without the cap they fit.
0
Reply
Thats the way it is
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Tolles Teil. Leider ist jedoch die Konstruktion nicht gut. die Griffe sind ca. 2mm länger als die Ausbuchtung des Modells. Ich habe das Teil nachkonstruiert und jetzt passt es perfekt.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
fitted my hex drivers perfectly (non capped handle versions).
0
Reply
Where can I find these hex drivers?
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Other Issues
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial
© 2024 MakerWorld