Wire Cover For PandaTouch AMS Faceplate
Copyright Claim
Wire Cover For PandaTouch AMS Faceplate
Boost
17
37
14
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
22 min
1 plate
Open in Bambu Studio
Boost
17
37
14
0
59
43
Released
Description
New Wire Cover for PandaTouch Faceplate for AMS raiser, link here :
https://makerworld.com/en/models/189190#profileId-208631
Comment & Rating (14)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
au top je recommande
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
all was good but unfortunately the riser I have is not the same as the one that you have modeled it for so it was really a tight fit. I was able to squeeze it in but it pushes the screen mount slightly which just makes it hit the door so slightly when opening. I only mention it because I saw one review that the door hit. mine didn’t until I wedged the cover in. not a complaint just wanted to pass along my experience.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very nice design, thank you
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Printed with Sunlu PLA+ and I am very happy with the result. Thank you for your work!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Didn't fit properly, not sure why.
The gap between the plate and cover was too small.
The designer has replied
0
Reply
hi, thanks for comment, can you show me your issue with photo ?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Snug fit!!!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
The designer has replied
1
Reply
Thank you for rating !
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld