Small - Standard Carabiner - Lock Thread
Remixed by
Copyright Claim
Small - Standard Carabiner - Lock Thread
Remixed by
Boost
7
18
8
Print Profile(1)
0.16mm layer, 2 walls, 15% infill
Designer
15 min
1 plate
Open in Bambu Studio
Boost
7
18
8
0
72
68
Released
Description
Remix of the locking carabiner to include threads on both sides of the joint for increased strength.
Comment & Rating (8)
All
Print Profile
0.16mm layer, 2 walls, 15% infill
Just perfect
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
At least when I printed it, it wasn't very functional. The latch doesn't seem to have any sort of locking mechanism and therefore made the hook sort of useless. This became more evident when scaling the model down. It might work better at larger sizes.
The designer has replied
0
Reply
hey. this was a supporting remix to show what I was talking about in a comment.
print the knurled knob from the original to make it make sense.
it’s already pretty small. any smaller and the threads are likely too weak to print right.
(Edited)0
Reply
Replying to @Sesheron
Cool. I'll give that a try. Thanks for responding with additional info.
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
Le mousqueton ne tiens pas en position fermée
Other Issues
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.16mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld