I made this so that the run-off flows straight where it belongs → Into a container, from where a condensate pump can move it to a bigger container. These have been tested and used with fabric pots, but plastic pots should work fine as well. I will eventually make a few different sizes. The saucer has a concave base so that the water drains off towards the drain outlet.

If you do print and use them please provide feedback so I can continue improving them.

If you find this as useful as I do please consider buying me a coffee.

I printed with supports for the hose adapter on a Bambu P1S with “0.16mm Optimal” settings. They seemed to work fine with the default settings but if I had to print again i would increase the top layer thickness a bit.

Enjoy:)

Diameter: 23 cm | 9 in

Hose Adapter OD: 13.1 mm | ½ in

https://openarcadia.com