German Mid-Century Mantel Clock - "Dugena"
German Mid-Century Mantel Clock - "Dugena"
Boost
131
176
20
Print Profile(2)
0.16mm layer, 2 walls, 20% infill
Designer
5.6 h
3 plates
AMS Clock Face
35 min
1 plate
Boost
131
176
20
7
151
168
Released
Description
Because they simply cost an incredible amount - print them out! ;)
The parts can all be easily put together with a bit of superglue - what goes where should be pretty obvious.. (or see “instructions” in the file descriptions).
- Tight Dimensions, so make sure your printer is accurate!
For the rear cover you need four 4x2 mm magnets.
The cover for the front clock hands is not tested.
I used this cheap movement here:
Amazon - I think any movement with these dimensions (56x56x15 mm) should fit.
Comment & Rating (20)
All
Print Profile
0.16mm layer, 2 walls, 20% infill
Very beautiful and easy to print. :)
Bambulab PLA Glow
The designer has replied
1
Reply
oh, i like the glow filament! nice print! thankS!
(Edited)1
Reply
Boosted
Print Profile
AMS Clock Face
It is awesome. Great print.
1
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 20% infill
So neat and prints up perfectly.
1
Reply
Boosted
Print Profile
0.16mm layer, 2 walls, 20% infill
Schön
The designer has replied
0
Reply
Schön!
0
Reply
Boosted
fantastic work thank you, printed in PLA, also added a second hand.
(Edited)
1
Reply
Sehr schönes Design!
ich habe die Uhr „Zeit-O-mat“ getauft🤪
The designer has replied
0
Reply
Sieht cool aus! Danke - aber das Design ist ja eigentlich nicht von mir.. ich habs nur nachgebastelt :)
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
Everything but the logo printed well. The untested cap for the clock movement didn’t fit, but the clock still looks great.
0
Reply
Do I need to add support?
The designer has replied
0
Reply
no supports needed.
0
Reply
Print Profile
0.16mm layer, 2 walls, 20% infill
I was looking for a small clock to put on my workbench/desk. This print was great easy to put together. Great job thank you.
1
Reply
Nice :)
1
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld