Print Profile(1)
0.2mm layer, 3 walls, 10% infill
Designer
3.5 h
1 plate
Open in Bambu Studio
Boost
61
69
5
0
57
18
Released
Description
A fun little dripping shelf storage tray, made after seeing a wooden one online.
Thew item prints as one flat piece and needs to be bent at the hinge. This can either be done by applying heat to the underside of the hinge with a blowtorch and bending slowly, or by heating your print bed to 60 degrees and letting the print sit on the bed for a few min until malleable.
I have printed it in PETG (green) and PLA (orange)
This is my first project, so I hope you like it.
Comment & Rating (5)
All
Print Profile
0.2mm layer, 3 walls, 10% infill
Cool dripping shelf! Had to resize it a little bit for my A1 mini but came out perfect.
1
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
thinner will be better. You need to bent immediately after finished, or it can’t be bent anymore
The designer has replied
0
Reply
Hi there. If you apply heat to the hinged section after printing you can bend it that way. It is not designed to be bent as soon as it has completed printing, the material will not be hot enough.
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 10% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld