Bambu clog pusher for hotend

Remixed by

Bambu clog pusher for hotend

Remixed by
Boost
18
48
6

Print Profile(4)

All
X1 Carbon
P1S
P1P
X1
X1E
A1

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
31 min
1 plate
5.0(2)

0.2mm layer, 6 walls, 25% infill
0.2mm layer, 6 walls, 25% infill
Designer
29 min
1 plate
5.0(2)

0.1mm layer, 6 walls, 20% adaptive infill etc.
0.1mm layer, 6 walls, 20% adaptive infill etc.
47 min
1 plate
5.0(1)

0.20mm - 8 walls
0.20mm - 8 walls
26 min
1 plate

Boost
18
48
6
0
53
20
Released

Description

How to use it:

Undo the hot end when cold, you don't want the fan running as it can touch things and break.

Beforehand make sure the hot end screws fits in the de-clogger, if not, clean the holes up.

it goes without saying that this is best printed in Petg or ABS. PLA is not best around the hot end ;)

Slide the piece onto the hot end top and lock in place by sliding the screws in.

Now heat up the hot end to a healthy temp like 250c.

When it's hot wait an extra 5min for the heat break and the top fins to get to temperature. if that's cold it won't work.

Then use the smaller key included with your X1 in the top of the De-clogger and apply pressure holding it like a syringe, mine was quite stuck so it took a good bit but then it went in all the way!

Reassemble everything and run a couple load/unload to make sure and clean up the inside. You could even do a cold pull with it still on if you want :)

I hope it works for you too, would be nice if Bambulab or someone else was to make this in metal ;)

Update: I added more clearance for the wires when mounted and I've improved the print bed adhesion

Update #2: Added new files of the V7, it is a shorter version with more clearances all around and better fit. The shortness helps when using a 1.8mm drill to clear the cold top of the hot end. if you have to choose , print that one! ;)

 

Great THX @Bounet

Comment & Rating (6)

Please fill in your opinion
(0/5000)

Print Profile
0.2mm layer, 6 walls, 25% infill
Works perfectly. Was hoping to never use it but you know how that goes.
0
Reply
Print Profile
0.1mm layer, 6 walls, 20% adaptive infill etc.
Nützliches Tool.
(Edited)
1
Reply
Thank you, this helps a lot.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more