Support

All my designs and mods are free to use and remix. They have a non-commercial license. If you enjoy this or any of my other designs you can send me a small donation using the link below. Thanks :)

• https://www.paypal.me/humebeamengineering

About

Based on my Vision P1P enclosure, here is a remixed version for those wanting to spice up their printer a little without going for the full build with removeable PC panels and top glass.

It is untested but should work, please start with one corner first and see how it fits. Let me know if any adjustment needs to be made.

The corner pieces attach with self tapping screws from inside and normal screws in the rear, these are supplied with the printer so you should have everything already.

Print Settings

I recommend using a minimum of 3 walls, top and bottom and infill of 20% or higher. Also, a wide enough brim is highly recommended to ensure bed adhesion, most parts are thin and tall. The files are best printed one at a time. For best bed adhesion I recommend Vision Miner Nano Polymer.

BOM - Bill of Materials

You can print the panels in just about any filament you like. Around 400 g of filament is required at the recommended print settings.

Although not required this double sided textured PEI is great, pretty cheap as well:

• Double Sided Textured PEI Build Plate