Search models, users, collections, and posts
Spool Foot
IP Report
Print Profile(3)
0.2mm layer, 6 walls, 25% infill
Designer
44 min
1 plate
0.2mm layer, 6 walls, 25% infill - prints upright for improved quality using tree supports and brim
7.4 h
1 plate
0.2mm layer, 6 walls, 25% infill - prints upright for improved quality - single count
1.1 h
1 plate
Open in Bambu Studio
Boost
16
43
16
4
52
42
Released
Description
I wanted to showcase my Spools in my cabinet, but they kept rolling around. Since there wasn't much clearance for the spoolholders i found, I needed something that could receive the rolling spool, and keep it in one place.
I created this Spoolstand / Spoolfoot to hold the spools in place.
The bottom is slightly angled to keep the spools from pivoting to the ceiling.
It has a generic width that allows for the 3 types of spools i have.
I'm sure most will fit.
Use support
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
Comment & Rating (16)