Bambu Lab Tools and Accessories Box Remixed by 鷄翼

Remixed by

鷄翼

3D Printer>3D Printer Accessories

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

Designer

2.9 h

1 plate

4.9(59)

V2 - PETG

Designer

2.9 h

1 plate

4.8(13)

Boost

187

373

647

332

Released

Description

24.02.2024 update：New Version of the insert box

-Adjusted the positioning hole size of nozzle wipers
-Adjusted the shape and depth of the Allen wrench cutout

-Adjusted the hole size of mounting screws，just lightly screwed into the their holes and it will hold in place

This is a X1/P1 basic tools and accessories insert for filament swatches rugged box（https://makerworld.com/zh/models/87023#profileId-93692）

The following parts can be accommodated:

-Two hotends + two mounting screws

-Four nozzle wipers + two mounting screws

-Five filament cutter

-Nozzle pin

-Allen wrench

-Seven lubricant grease and thermal grease

Comment & Rating (78)

@chadholt100

Print Profile

0.2mm layer, 3 walls, 15% infill

FANTASTIC!

The designer has replied

@user_3763349769

外围的盒子怎么打印的？有文件吗？谢谢

@chicken19890802

Replying to @user_3763349769 :

简介不是放了链接吗，基于以下模型二次创作那里也可以跳转

@user_3763349769

Replying to @chicken19890802 :

谢谢

@MakerBreaker

Works good! A few areas where this could be improved: 1. The roller holes are too deep so when the lid is closed and the case is ratlled, the rollers get loose. The tolerance on the width of the holes could be tighter as well which may also help. 2. There should be a deeper cut out for the long allen wrench so you can better grab it. It's very hard to grab when seated in its spot. 3. The screws have to actually be lightly screwed into to their holes to stay put, not sure if this is intended design or not. They will rattle around in the case otherwise.

The designer has replied

@chicken19890802

Thanks for your suggestions for improvements，I have updated the new version model. New model adjusted the positioning hole size of nozzle wipers and the shape and depth of the Allen wrench cutout. Just as you guessed，the old model was designed to hold the mounting screws in place by screwing them into the holes，in the new model I adjusted the depth the screw needs to be screwed into the screw hole.