Stackable spinning organizer

Copyright Claim

Stackable spinning organizer

Boost
112
111
0

Print Profile(1)

All
P1P
P1S
X1
X1 Carbon
X1E
A1

0.3mm layer, 3 walls, 10% infill
0.3mm layer, 3 walls, 10% infill
Designer
34.8 h
7 plates

Boost
112
111
0
2
121
40
Released

Description

I wanted something I could easily break down smaller and take with me to shows. This model has both a larger square base for taller stacks or a smaller circle base for minis or small stacks. There is a bottom shaft labeled. and the center shaft is only needed if going three tiers or higher. The top shaft has the shorter tab for the top cap. Two variations of the top cap, one solid, and one with a slit as photoed for signs or label. There are also several tray variant between open up to 4 section trays. These spin freely with no added parts or equipment. Mine was printed in petg. This model is for personal use only for Commercial use it is available on Cults.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.