Bambu Lab Manual Belt Tensioner X1C/P1P/P1S by palmer_inc

palmer_inc

3D Printer>3D Printer Parts

Print Profile(0)

Add the first print profile to earn points

Boost

Released

Description

Manual Belt Tensioner for Bambu Lab X1C, P1P and P1S
Its in Testing.

I have it in my X1C and it Works very well. no problems in Print.
I even think that the print quality has improved, especially in terms of accuracy

There is a problem when it is tensioned and you loosen the screw then the screw turns with it. If anyone has a solution please contact.

Coming V2

Self locking nut delete

Coming Spring in this place.

You need:

2x M3x20mm Cylinderhead screw
4x M3 washer
2x M3 hexagon nut
2x self-locking mother

print in ABS or better

Comment & Rating (5)

@Tdoening

Hi What do you mean "There is a problem when it is tensioned and you loosen the screw then the screw turns with it. If anyone has a solution please contact." turns with what?

The designer has replied

@palmer_inc

the print press on the screw nut, so the nut doesnt move, you screw the screw out. you need to build new (screw and nut in the right position) or pressure on the screw. sry english is bad. when you print them you will see why, its not so a problem.

(Edited)

@Tdoening

Replying to @palmer_inc :

unfortunately I still don't understand when you loosen the tensioner, what rotates with screw? - nut or - self-locking nut (this one should) edit: I replaced the nut in the tensioner piston with an insert

(Edited)

@theRaz

Is this thing meant to be used when adjusting the tensioners and removed afterwards?

The designer has replied

@palmer_inc

you must remove the original one to use it, it change a little bit the quality for the prints, slithly better quality at the edges and better accuraty Yes its move afterwards the screw

(Edited)

No more