Philadelphia Flyers Light Box
Copyright Claim
Philadelphia Flyers Light Box
Boost
7
12
4
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
4.6 h
2 plates
Open in Bambu Studio
Boost
7
12
4
1
15
22
Released
Description
Hello Everyone
Thanks for visiting and i hope you enjoy the Philadelphia Flyers light box.
Prints face down very easy print with NO supports
Check out my other files and give me a follow :)
Send me a message to get a lifetime commercial license for all my files :)
Comment & Rating (4)
All
did you have hole in yours so that the light shined throught parts it should not have? ive tried asjusting setting flow ratio, first layer speed...and those seems not change much for me
The designer has replied
0
Reply
nope no holes might need to adjust your flow rate to 1.1 and add an extra first layer
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld