Ever wanted Taylor Swift to stare back at you as you stop reading for the night? With this bookmark, allow Ms. Swift to not only mark where you are in your book, but also guilt trip you with her eyes as you slowly shut the book in her face.

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.2mm

Filaments Used:

• PLA Siddament Black Transmission Distance: 0.2
• PLA+ Sunlu Grey Transmission Distance: 1.4
• PLA Sunlu Beige Transmission Distance: 8.2
• PLA META Sunlu White Transmission Distance: 9.6

Swap Instructions:

• Start with Black
• At layer #13 (0.68mm) swap to Grey
• At layer #22 (1.04mm) swap to Beige
• At layer #30 (1.36mm) swap to White for the rest.

This is a thin print. Make sure your filament has been calibrated to be able to handle the low layer height!