Made this for a friend hope you like it!

If you only have one AMS leave the last filament empty so that it pauses when it gets to it. Then switch all the rolls needed. This is how I do mine.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
    PLA BambuLab Basic Black Transmission Distance: 0.6
    PLA BambuLab Basic Blue Transmission Distance: 4
    PLA BambuLab Basic Orange Transmission Distance: 10
    PLA Kexcelled Light Brown Transmission Distance: 3.5
    PLA BambuLab Basic Yellow Transmission Distance: 6
    PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
    Start with Black
    At layer #13 (1.12mm) swap to Blue
    At layer #15 (1.28mm) swap to Orange
    At layer #24 (2mm) swap to Light Brown
    At layer #28 (2.32mm) swap to Yellow
    At layer #31 (2.56mm) swap to Jade White for the rest.