So the first question you have to ask when you print a super sledge is where the heck am I going to keep it? Well, here you go, a nice simple and secure wall mount for your amazing but large weapon. This has been specifically formed for my new design (as pictured - can be found in my other uploads) but this will hold the “official” release with a bit of wiggle room.

As you can see, this is a remix of AkashaDesigns wall mount, and there was a a lot to change. Cosmetically I removed the previous engraving and replaced it with the Fallout logo. Mechanically I modified the entire front half to fit the new design. This meant raising the holder and front arms to allow the unit to fit, and shaping the hole to match the new design, then a few tweaks for a more efficient print.

Three prints are available - AMS, embossed and engraved. If you want any other versions please ask and I'll be happy to help.

Please like and rate this design, your support is appreciated.