Bambulab bed holder clips by dieggs

dieggs

3D Printer>3D Printer Accessories

GIF

Print Profile(3)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 3 walls, 10% infill

Designer

33 min

1 plate

3.8(5)

ABS, 0.24mm layer, 5 walls, 99% infill

19 min

1 plate

5.0(3)

PETG, 0.24mm layer, 5 walls, 99% infill

23 min

1 plate

5.0(2)

Open in Bambu Studio

Boost

137

Released

Description

Those clips fix your magnetic printing bed on place. The warpin of the entire bed can happen when printing large models specially with ABS ASA or other “warping materials". Enjoy

Minimum printing material: Petg

Recommended printing materials: Abs, ASA or Polycarbonate

Comment & Rating (16)

@jf.marinaoka

Print Profile

ABS, 0.24mm layer, 5 walls, 99% infill

print great but doesn't work with my engineering plate since I it is the other side!!! I will try my ASA on a other plate thanks

@leon411

Die Teile sind leider etwas zu eng...

The designer has replied

@dieggs

Versuchen Sie zunächst, sie von unten einzuführen. Sie werden sehen, dass sie richtig laufen👍🏼

@leon411

Das habe ich getan, allerdings wurde durch das befestigen die Druckplatte beschädigt. Da die Teile dann doch etwas zu eng waren.

@eberendsen

Print Profile

0.2mm layer, 3 walls, 10% infill

too much clearance

The designer has replied

@dieggs

the clearance it's ok. They have to be tight! Try to insert them bottom first. Adjust your review please👍🏼

@colombod

It is a problem when you have double face print sheet, the from parts won't work always, the back part on the right seems to be in the way of the first lines printed.

The designer has replied

@dieggs

Thanks for the feedback. Do you have some photos to show me the problem of the lines?