Rose Ring Box! (Print in Place) by Kevbot.

Kevbot.

Fashion>Other Fashion Models

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

1.9 h

1 plate

4.7(33)

Open in Bambu Studio

Boost

360

467

655

274

Released

Description

This is the second part of the Valentine's Day drop.

It is shaped like a rose, and it fits in the palm of your hand. It's print in place and has holes for magnets to keep it securely closed. It also has a cut-out for a ring on the inside, and the neat part is that it will fit a wide variety of ring sizes without them falling out.

The ring will stay in place because of a separate spring that pushes against the ring to keep it from moving around. -This spring is printed separately and needs to be inserted mid-print (I've included a stop for it in the 3MF file, along with stops for the magnets). *see photo for more details

This model is for PERSONAL USE ONLY, if you want a commercial license and access to more awesome models you can get it on my patreon https://www.patreon.com/kevbot_3d

You will need 16, 6 by 3mm Neodymium Magnets. These are the magnets I use if you are interested:

60 Pack on Amazon: https://amzn.to/47pQFaj

100 Pack on Amazon: https://amzn.to/3Sa8beg

Have a great Valentine's Day!

Sincerely,

Kevin

Disclaimer: Some links in this description may be affiliate links. This means I may earn a small commission if you click them and make a purchase. It's no extra cost to you, but it truly helps me to keep producing free designs. Thank you!

Comment & Rating (51)

@nikkolaus

Print Profile

0.16mm layer, 2 walls, 15% infill

Print was good, but the instructions were unclear on the necessary direction of the spring. I had to print this twice. If printed in the wrong orientation the spring gets jammed and the whole print is trashed. Not sure if it's just me, but the hinges were a bit iffy in layers, and weak to side-to-side forces (tested on the bad print). Item doesn't sit flat on tables - topples over. The ring stays firmly in place even if tipped upside down, which is great! The rose top looks amazing.

(Edited)

@nikkolaus

More photos for your viewing pleasure.

(Edited)

@FFEMT89

Print Profile

0.16mm layer, 2 walls, 15% infill

great model, see my comment for more details

@FFEMT89

Great model, I printed without the magnets. The pause for the spring should be inserted at layer 50. I added a negative modifier in the slicer so it would stand on it's own and changed the top and bottom surface patterns to octagram spiral to dress it up some. I also printed at .16 layer height and had no issues at all.

@risewithin

dang I printed from my phone and didn’t even read the description. I was trying to find out what this spring thing was. ooops 😂😂 thanks for the file. Printed in PETG