Print in Place SD Card Holder
Copyright Claim
Print in Place SD Card Holder
Boost
35
39
21
GIF
Print Profile(2)
0.2mm layer, 2 walls, 15% infill
53 min
1 plate
A1 Mini - 0.2mm layer, 2 walls, 15% infill
1 h
1 plate
Boost
35
39
21
3
133
101
Released
Description
This is a print in place SD card holder. It uses cone hinges and has a latch so it can snugly snap into place when you close it. It can hold 4 SD cards and 8 Micro SD cards. This SD card holder is especially good for travel. Because of its latch, your SD cards won't just fall out. If you like this model, make sure to give it a like! And don't forget to follow us for more cool creations like this one!
Find us on Instagram here
Find us on YouTube here
Comment & Rating (21)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
sweet simple the only thing I wish is that there were some variants one where it held only micro SD cards and one where it held only SD cards because then I could print tons of these for all my buddies and film and video
The designer has replied
1
Reply
Boosted
Wish granted - Check out the remix I Just published:
https://makerworld.com/en/models/391282#profileId-292310/
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Awesome print! I love the print-in-place case. all the tolerances are perfect. Thanks!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
I've tried a few card holders, but none have been as good as this one!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
printed in place perfectly and my cards
0
Reply
Great print on A1, thanks
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
That's a cool remix, nice one!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
very practical
0
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRemixes (1)
Related Models
© 2024 MakerWorld