PRINTED THIS FOR A FRIEND
After seeing some nice artwork someone posted on Facebook from Samhain1992
I THOUGHT WOULD WORK INTO A NICE HUEFORGE PRINT.
USED THE FOLLOWING SETTINGS… can be done with or without AMS
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Tough Vermilion Red
PLA BambuLab Basic Yellow
PLA BambuLab Basic White
Swap Instructions:
Start with Black
At layer #9 (0.8mm) swap to Vermilion Red
At layer #20 (1.68mm) swap to Yellow
At layer #25 (2.08mm) swap to White for the rest.