Easel for HueForge or photos (Print in place)
Easel for HueForge or photos (Print in place)
Boost
35
36
21
Print Profile(1)
0.12mm layer, 2 walls, 10% infill
Designer
32 min
1 plate
Open in Bambu Studio
Boost
35
36
21
0
124
115
Released
Description
A small easel to display your HueForge prints or photos. It can be easily scaled according to your needs.
Comment & Rating (21)
All
Print Profile
0.12mm layer, 2 walls, 10% infill
Rápido de imprimir, ligero y minimalista, un 10!!
The designer has replied
1
Reply
muchas gracias!!!
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
worked but had to go 50% dunno if it's just my a1 but this caused a big huge clog, bad one that almost got in between the nozzle, and I think it happened before , just could be bad luck of this shape as it's a big triangle with these lines, that are straight and long, it landed itself to a big clog, but could be unrelated but I shouldn't have walked away , but I know I'm not crazy because it did happen and I realllly think the speed of acceleration is a lil too high and it can detach, but drag!
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
tres bon fichier
facile à imprimer
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
printed great. no complaints
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
hm 12g? this may be the largest easel on makerworld for smallest filament
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
Great quick print. Used as is once and dropped the X and Y down to 50% leaving the Z alone. came out great and print in place hinge still worked fine. Super fast print.
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
etwas wackelig, aber Bild steht gut drin. Untergrund darf nur nicht sehr glatt sein, sonst wird es instabil
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.12mm layer, 2 walls, 10% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld