A1 mini & A1 PCB Face by Wojciech Kawa

Wojciech Kawa

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

2 plates

4.8(90)

Open in Bambu Studio

Boost

186

294

120

366

362

Released

Description

The front of the extruder as a PCB.

I tested several color variants and it turned out that the path and the background must have a high contrast so that the paths can be seen best. In my case, the best colors were matte black as the background and gold as the paths.
There are of course two versions for the A1 mini and A1.
there are two versions of the rotating center in the project (I couldn't decide which one is better - you decide)

Before you start printing, make sure you have a clean plate (Wash it in warm soapy water or IPA). The first layer has a lot of small elements that must stick well to the plate.

If you have printed it, please leave a rating.

Before installation, the original front and the rotating element must be dismantled.
During installation, the eye should be pressed as far as it will go. After putting the face, the eye should be flush with the face or deeper.
When assembling, make sure that the top latches are flush with the top edge before pressing from the front.

See my other projects.

Assembly instructions below.

Comment & Rating (120)

@OgiArts

what first layer i need to set i printed it out 2 times on 0.3 and 0.4 but its to thin ? i dont know what i am doing wrong

The designer has replied

@WojciechKawa

The height of the first layer for noozle 0.4 is 0.2mm. Extrusion width 0.45mm, but it is best to set Arachne and then it will select the width automatically. The order of colors is also important, you need to print the paths first.

@OgiArts

Replying to @WojciechKawa :

0.2 layer height is included. I want to know what setting I should make for the first layer because I don't think it gets printed by default http://prntscr.com/zh80vmMJy5oA

@WojciechKawa

Replying to @OgiArts :

The only thing I change on the "Quality" tab is "Wall Generator" to Arachne, the rest is on default settings. The order in which the colors are printed is important so that the paths are thick.

@FinnishHer

Made with smooth PEI plate👌

(Edited)

@OgiArts

o need to buy the smooth plate damn sexy af and the purpel its tranparent ? looks like that

@FinnishHer

Replying to @OgiArts :

its two colored silk. the prints feels awesome after the smooth plate, just wanna touch it all the time😂

@OgiArts

Replying to @FinnishHer :

XD mmm how Yes touch me XD

@STLDad6

Print Profile

0.2mm layer, 2 walls, 15% infill

really nice. my AMS messed up my color choice. going to print again later with different colors Okay just printed it again. so much better. Thabk you

(Edited)

@Robybobo77

Print Profile

0.2mm layer, 2 walls, 15% infill

poco rifinito e non si incastra perfettamente

The designer has replied

@WojciechKawa

Perform Flow Rate Calibration. It is clear that this is the problem, and certainly not in the design. Also make sure the table is clean to ensure good adhesion. https://wiki.bambulab.com/en/software/bambu-studio/calibration_flow_rate

(Edited)