Bambu Lab LED Shield Ventilated Top Glass Riser for X1 and P1 Series
Remixed by
Copyright Claim
Bambu Lab LED Shield Ventilated Top Glass Riser for X1 and P1 Series
Remixed by
Boost
51
89
14
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
8.8 h
4 plates
0.2mm layer, 2 walls, 10% infill
Designer
8.8 h
4 plates
Open in Bambu Studio
Boost
51
89
14
0
271
215
Released
Description
Minimalist top glass riser with added ventilation slots and TPU Light Shield, which will support 8 or 10 mm LED's.
For P1 series USB port only use a 5V LED and do not excess the 1.5A of the port, i used and cutted a LED strip like this one:
For full enclosure is better to print it in petg, abs or asa.
Personally used PETG for the structure and TPU for the light shield with the following variation to the standard 0.2 setting in Bambu Studio to apply only for the structure:
Infill: 10%
Support: No supports
Brim: manual, 10mm
Comment & Rating (14)
All
Thanks looks great easy to print to
1
Reply
Great riser. Adding lights can mess with the LIDAR. So, I would then leave them off most of the time.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld