Apple pencil gen 2 holder
Copyright Claim
Apple pencil gen 2 holder
Boost
20
53
16
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
43 min
1 plate
Open in Bambu Studio
Boost
20
53
16
2
83
81
Released
Description
This is an Apple pencil gen 2 holder. Print it without support or brim.
To give it some weight, I filled the bottom with lead pellets and poured some two component resin.
After that I glued a round rubber sheet underneath to prevent it from sliding around the table.
It don't know if it fits the first generation Apple pencil. If someone tries, let me know. I can make modifications to make it work.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
great Design, it’s work great too without filling the bottom
The designer has replied
1
Reply
Looks good! And good to know it also works without giving it some extra weight!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Great print out
1
Reply
Boosted
Print Profile
0.2mm layer, 2 walls, 15% infill
printed great with no visual flaws
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Other Issues
The designer has replied
0
Reply
Curious to know what the "Other Issues" are. Anything I can do to improve on the model?
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld