I've been printing a lot of very small pieces in resin, for my wife's hobby, and had issues with my normal rinse bucket / basket having too big of a mesh. This caused the pieces to fall through the basket, into the bucket, and it was really difficult to pick them out again.

This basket is intended to be holding very small pieces, and used for rinsing your tiny resin pieces in a bucket of IPA.

I printed mine in PETG, and it was stringing a bit, but a heat gun and a few rinses took care of that. I imagine it'll probably print and use fine in PLA as well. Print standing up on the plate, no supports needed.