The Sun
The Sun
Print Profile(1)
Description
Here is a Hueforge print of the sun. For the one shown in the picture, I used Bambu PLA Basic for the red and orange, and Sunlu PLA Meta for the black and white. The instructions are as follows:
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm
Swap Instructions:
Start with Black
At layer #7 (0.64mm) swap to Red
At layer #12 (1.04mm) swap to Yellow
At layer #19 (1.6mm) swap to Jade White for the rest.
Filaments Used according to Hueforge:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 5
PLA BambuLab Basic Yellow Transmission Distance: 6
PLA BambuLab Basic Jade White Transmission Distance: 5
License
You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.
Comment & Rating (3)