Goku Red Sun by Hazardousafe

Hazardousafe

Generative 3D Model>Hueforge & Lithophane

Print Profile(2)

All

X1 Carbon

P1S

P1P

X1E

0.08mm layer, 2 walls, 100% infill

Designer

6.1 h

1 plate

5.0(3)

0.08mm layer, 2 walls, 100% infill

Designer

4.3 h

1 plate

Boost

Released

Description

Project: Goku Red Sun.hfp
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

The Model is 171.69x240mm in size
You may print at higher layer heights below the Min Depth of 0.48mm
The Max Depth is 2.9mm and the Actual Depth is 2.6mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 3 unique filaments

Swap Instructions:
Start with Black
At layer #11 (0.96mm) swap to Red
At layer #20 (1.68mm) swap to Jade White
At layer #21 (1.76mm) swap to Black
At layer #23 (1.92mm) swap to Jade White for the rest.

Comment & Rating (9)

@hoodedmonk

Boosted

Print Profile

0.08mm layer, 2 walls, 100% infill

This was one of my first prints so I didn't change any setting but I did change the colors because I didn't have white. Im using the A1 with AMS straight out the box after calibration test and firmware update. It printed alright, I don't know how to fix it but the edges came out warped for me. Bottom edge probably came out the best. If you have any suggestions, solutions or tips please let me know.

The designer has replied

@hazardousafe

I would try washing your build plate with dawn dish soap and water to start with. It looks like a bed adhesion issue. Also, I use 99% Isopropyl alcohol to wipe down by build plate before each print to help avoid this. I will also try to create a print profile for those colors for you.

@yumakuga81

yeah, I'd suggest the same as he said above. Wash the plate down real well with soap and warm water, then use 99% isopropyl alcohol after it dried. Glue stick if available, not necessary. Also if you keep the house cold, or a fan in the room on high, these can cool the print some.

(Edited)