Filament Spool Hanger
Copyright Claim
Filament Spool Hanger
Boost
18
26
7
Print Profile(3)
Extended - 0.2mm layer, 2 walls, 20% infill
Designer
1.3 h
1 plate
Short - 0.2mm layer, 2 walls, 20% infill
Designer
1.2 h
1 plate
Bearing - 0.2mm layer, 2 walls, 20% infill
Designer
1.2 h
1 plate
Open in Bambu Studio
Boost
18
26
7
2
45
66
Released
Description
There was a couple remixes of this Filament Spool holder I used for a particular job and I've combined some of those remixes in to the best most useful way i've found.
The first profile is the smaller original width
The second profile is extended width for wider spools
The third profile is also extended width but with option to run x6 680ZZ bearings (3 on each side) for more smoother option and spool compatibility.
Comment & Rating (7)
All
Print Profile
Extended - 0.2mm layer, 2 walls, 20% infill
I'm setting up a closet as a printing station and this makes my life so much easier. Thanks.
The extended version is the one that fits most of my spools, the normal one is a bit narrow.
(Edited)0
Reply
욱일기내. 나치새끼
0
Reply
Print Profile
Short - 0.2mm layer, 2 walls, 20% infill
I love these hangers. It is helping me to keep my filament organized
0
Reply
Print Profile
Short - 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Extended - 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Extended - 0.2mm layer, 2 walls, 20% infill
0
Reply
Print Profile
Extended - 0.2mm layer, 2 walls, 20% infill
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld