Ultimate Vision Spool Holder

Tried a few if not most of holders for Vision Enclosure on here and none of them are up to my liking.

Some mount spool too far back, others are too weak to a point they crack or spool falls off.

Took a few things from one, a few from other and made my own version.

I recommend using PETG (PLA might work) to avoid sagging after some time.

From my experience and use for last few weeks, spool did not sagg!

You need around 150mm long PTFE ‘extension’ and just reuse factory coupler to fix them together.

Parts you need:

• 2 x 608ZZ bearings
• 4 x M3*18mm flathead screws
• 1 x M4*14mm countersunk screw
• 1 x PC4-M10 Pneumatic Connector - OPTIONAL (you can just push PTFE tube trough)

Base I used is from apex3D.