Golf Tee
Copyright Claim
Golf Tee
Boost
36
47
11
Print Profile(1)
0.2mm layer, 2 walls, 80% infill
Designer
47 min
1 plate
Open in Bambu Studio
Boost
36
47
11
0
181
218
Released
Comment & Rating (11)
All
Really fun to print, have not used them yet. Small issue with printing, bottom cup has print lines that fell off. Will likely not affect performance, just had to cut them off. Printed nine copies in PLA-CF
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
Overhang a little defective in the center of the cone. Other than that, it was perfect!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
enjoy the design and hoping it holds up to the task. off to the links to give it a go
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
exactly as pictured - great for setting up large drivers
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
Other Issues
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
Strength Issue:Only lasts for one drive so if you don't mind printing a dozen a round you will be fine.
0
Reply
Print Profile
0.2mm layer, 2 walls, 80% infill
(Edited)
Strength Issue
0
Reply
License
This user content is licensed under a
Creative Commons Public DomainRelated Models
© 2024 MakerWorld