nice test for the printer :)

No issues, and showed up a small issue in the front corner of my build plate that must have had a finger print, so was a worthwhile exercise. Cant believe how well the A1 mini can put down a first layer, truly amazing. One point of note; this test print measures 175mm square, not the full 180m of the quoted build area, but unsure if this is a limitation from the calibration line etc.

verry good, think it wil be all perfect of i wash the plate before print

very good print so helpful

good thing clean the plate and test flat

After device reset, running automatic calibration with Smooth PEI plate and running First layer (with the latest v1.9.1 BambuStudio) test the level of the later os pretty ok but the lines seems to be splited in the center (on the plate side) P.S. Defect in the bottom right caused by by cat’a hair

good job

it just works, great tool