Bunny - Garden decoration
Boost
12
29
2
Print Profile(3)
Bunny With Holder
Designer
1.7 h
1 plate
Bunny Holder
Designer
23 min
1 plate
Bunny No Holder
Designer
1.7 h
1 plate
Boost
12
29
2
0
32
33
Released
Description
Bunny decoration for a garden or a flowerpot.
Please be aware that the holder is modeled to fit precisely into the bunny. I haven't added any tolerance, so some printers will require to slightly shrink the holder or use sanding to fit the holder into the bunny.
The following screw is required: M3x10 Screw.
It was printed from PETG with 0.2mm layer height.
Comment & Rating (2)
All
Print Profile
Bunny Holder
These printed perfect for me, however, I would suggest in the design to make the stake longer, or provide a separate version with a longer stake. As where I placed these in a mulch bed needed lots of height to dig in and still be visible above the ground. I ended up cutting the existing stake in Bambu Slicer and extending the bottom piece. Also would recommend to make the stake tip a bit pointier, so help pierce the ground better. Extending my piece the way I did automatically stretched it out.
0
Reply
Print Profile
Bunny With Holder
These printed perfect for me, however, I would suggest in the design to make the stake longer, or provide a separate version with a longer stake. As where I placed these in a mulch bed needed lots of height to dig in and still be visible above the ground. I ended up cutting the existing stake in Bambu Slicer and extending the bottom piece. Also would recommend to make the stake tip a bit pointier, so help pierce the ground better. Extending my piece the way I did automatically stretched it out.
0
Reply
No more
License
This work is licensed under a
Creative Commons AttributionRelated Models
© 2024 MakerWorld