Gardena quick connector set

Copyright Claim

Gardena quick connector set

Boost
655
1129
34

Print Profile(3)

All
P1S
P1P
X1
X1 Carbon
X1E
A1
A1 mini

0.12mm layer, 4 walls, 30% infill
0.12mm layer, 4 walls, 30% infill
Designer
7.9 h
2 plates
4.8(23)

Print needed connector only 0.12mm layer,4 walls,30% infill
Print needed connector only 0.12mm layer,4 walls,30% infill
10.3 h
13 plates
4.5(2)

Inner 1" (M18) with collar
Inner 1" (M18) with collar
1.1 h
1 plate

Boost
655
1129
34
35
912
261
Released

Description

Welcome! I am pleased to share with you the Gardena quick connector set that I designed in various sizes to perfectly meet different connection needs. The set is available with different threads and sizes:

  • External and internal threads
  • Sizes: 3/8", 1/2", 3/4", 1" (M18)
  • Traditional BSP thread

Material Choice For the best results and long lifespan, I recommend the following materials for printing: PETG, ASA, ABS. PLA can also be used, but I strongly recommend the former materials.

Sealing Rings Sealing rings can be printed from TPU material as it is flexible and waterproof. However, for the best results, I recommend using factory sealing rings, especially O-rings, to ensure maximum water tightness and long-term reliability.

It's important to note that high pressure can cause leakage or other issues, so I do not recommend using the connector at high pressure!
I experienced slight leakage at 6 bar, so please don't leave negative feedback because of this. Thank you!

For supports, if possible, use support material, or use PETG-PLA or PLA-PETG interface layer mode.

Thank you for choosing this 3D printable Gardena quick connector set! I hope you find it useful. If you have any questions, feel free to reach out to me!
If you have any suggestions or requests, please contact me.

This is a revised version of my original model with some additional sizes: https://www.thingiverse.com/thing:4904221

Comment & Rating (34)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.12mm layer, 4 walls, 30% infill
Great model, thanks!
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
finally, printed something that is also useful ;) thanks!
0
Reply
Boosted
Print Profile
0.12mm layer, 4 walls, 30% infill
énorme travail et model parfait je recommande
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
Perfect to join two hoses in the garden to reach the pressure washer. Requires a little care removing supports.
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
sieht gut aus, Stützen gingen etwas schwer ab, aber TOP
0
Reply
Hi need an angled one
0
Reply
Hi, do you also have these for the Gardena Pro System? Btw: awesome job!!
0
Reply
Print Profile
0.12mm layer, 4 walls, 30% infill
This was a cool design
0
Reply
Good
0
Reply
Boosted
very helpful, thanks
0
Reply