PS5 Headphone and double controller stand
Remixed by
Copyright Claim
PS5 Headphone and double controller stand
Remixed by
Boost
60
68
27
Print Profile(3)
0.2mm layer, 3 walls, 15% infill
Designer
15.7 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
16.8 h
1 plate
0.2mm layer, 3 walls, 15% infill
Designer
15.2 h
1 plate
Boost
60
68
27
4
160
82
Released
Description
When you get your son a controller stand and his headset, he gets another controller as a present.
What else to do but remix it and make him a new holder.
I'll share this model with you.
REMOVE THE SUPPORT GENTLY, USING PLIERS.
update 10.02.2024 added profil with less filament
Comment & Rating (27)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
Hammer geil nur die Reste lassen sich Schwer entfernen sonst Hammer Idee wirklich geil
(Edited)
The designer has replied
0
Reply
Yes, it takes a little practice, I could have made the support stronger because it is very high. I made a few prints to get there :) thanks for 5 stars
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
it is perfect
The designer has replied
0
Reply
Thanks for liking it 😉
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
This is a great print.
The designer has replied
0
Reply
Great, look very good 😉, and thanks for 5 stars
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Support with high load and small angle.
No gap between support and interface.
0
Reply
I had just to the top headphone piece break when removing supports do you have a file for just that piece?
The designer has replied
0
Reply
yes you have model with two parts
0
Reply
yes I do
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Cane out really nice! Now all I have to do is paint it to my liking.
The designer has replied
1
Reply
Thanks 🤷
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
my friend thought it was epic! gave as a gift
The designer has replied
0
Reply
Thanks for niceee reply :)
0
Reply
Boosted
Print Profile
0.2mm layer, 3 walls, 15% infill
Excellent!!! Thank you.
The designer has replied
0
Reply
Thanks 🤗
0
Reply
just tried to print this and well we almost had a complete piece not sure what happened but on the final part it broke!
The designer has replied
0
Reply
When did you remove the support? I pinch the support in the middle with pliers, then lightly towards the top. But it's a reinforced tree structure because it broke off while I was digging. It is also necessary to adjust the print speed according to the filament
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Works like a charm, tienes out great!
0
Reply
This remix is based on
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivativesRelated Models
© 2024 MakerWorld