Bambu Lab TPU Guide Rod Cover/Sleeve (P1P P1S X1 X1C)
Copyright Claim
Bambu Lab TPU Guide Rod Cover/Sleeve (P1P P1S X1 X1C)
Boost
45
116
19
Print Profile(2)
0.2mm layer, 2 walls, 10% infill
Designer
18 min
1 plate
0.6mm nozzle, 0.3mm layer, 4 walls, 25% infill
22 min
1 plate
Boost
45
116
19
1
194
117
Released
Description
Has a slit in it so it can just slide over the rod for an easy install! Prints in TPU and fits well in the holes of the Bambu Lab rods at the bottom of the printer. Mainly to prevent plastic bits or screws when working on it from falling down in there lol I recommend a tiny bit of grease on the rod/inner hole of the print just to keep things smooth :)
Please note that you MUST remove these temporarily prior to a maximum height print or when lowering the bed all the way, otherwise the bed will lower into the cover. To be safe any print over 220mm I would take these out.
Comment & Rating (19)
All
Print Profile
0.2mm layer, 2 walls, 10% infill
👌🏿 Perfect 🙏🏿Thanks
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Good.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Top
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
worked well on smooth PEI plate.
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Came out great slipped right in. Done with inland TPU
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
No dust,no damage!
I love too Print TPU!
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
absolute Passgenauigkeit
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
fit perfect, does exactly what it's supposed to
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld