Full width tool holder for Bambu X1C/X1/P1S with modular infill to make any fit-in tool holders as 34.5mm hight.

1 glue stick or pole hole, 1 drawer, 13 modular tool infill hole.

This is optimized tool holder for AirVent Riser below but still you can use it as standalone.

BambuLab X1/X1C/P1S Lid Riser w/ AirVent and LED Slot by blazentrance - MakerWorld

In case the hight of riser you printed and set on the printer is not exact 34.5mm tall based on the printing accuracy or foam damper hight gap, you can just cut the bottom of tool box via Bambu Slicer “Cut” function, also you can extend the hight with similar way.

My own case I do not need any change but if you need any change please leave a comment it helps a lot for the improvement.

Infill

Major Infill X Y Z 29.1 x 11.6 x 30.00mm as high ver. / 29.1 x 11.6 x 25.9mm as low ver.

Minor Infill(center botton only) X Y Z 22.4 x 11.6 x 25.9mm

I prefer through hole to make very easy design.

How to use

Print whole parts

Use thin double sided tape(you can cut bottom of right and left main module based on that tape thickness) or

しっかり貼れてキレイにはがせる粘着剤 ひっつきシリーズ｜コクヨ ステーショナリー (kokuyo-st.co.jp)

ひっつき虫はとても薄くても固定力が強いので高さ調整不要

You can add more infill module based on your tool just make the whole on the infill spend 1 min for new design.