DJI Pocket 3 Hard Travel Case Print in Place! Remixed by Jerich0

Remixed by

Jerich0

Hobby & DIY>Electronics

GIF

Print Profile(1)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.7 h

1 plate

3.7(3)

Open in Bambu Studio

Boost

101

Released

Description

wanted a travel case that protected the pocket 3 on all sides vs the case it came in (eg. to throw in my travel bag).

used the excellent parametric box design, and created a hard travel case that is easy to print in place for the pocket 3.

hope you like it!

oh, I recommend putting some felt tape (which i show in the photos) so that your pocket 3 is secure, tape only top and bottom, plus the side with the screen, if you tape on all sides, the fit will be too tight. I purchased this from amazon for this purpose.

Note: do not leave the print cooling on the plate too long before you try to move the hinge. I've noticed (while printing some cases for friends) that if i left the completed print cooling on the print bed for some time, I can no longer move the hinge without risk of breaking. However, when it just finishes the print, there shouldn't be any issue moving the hinge and having it permanently work. So be warned, cooled down hinges stick. Thanks.

if you liked this model - check out

Comment & Rating (6)

@le_ti_lik

Boosted

Print Profile

0.2mm layer, 2 walls, 15% infill

Good but needs to be slightly larger to accommodate more soft padding inside the case.

The designer has replied

@Jerich0

hello, thanks for trying out the print. Can you elaborate on the sizing? the design was meant to be a tight fit with the felt tape i used, largely because i didn't want the camera moving around in the case when i put it in my backpack. That said, due to material shrinkage, i can see that the tolerance may be a little tight. Can you suggest where i should widen the case? width, height or length? would printing it at 101% help your situation? let me know and i'll see what i can do to make the design better. Once again, thanks!