Storage rack for pool noodle swords

This is a holder sized to fit the Pool Noodle Sword handles (version 1) created by ToddysTrinkets and shared here on Makerworld.  This holder will fit on the bed of a P1S or X1C in two parts which are then superglued together.  It will fit up to five pool noodle swords.  It has been tested with the first profile (Updated screw, 19mm hole, all V1 types) on Toddy's upload. I haven't tested it with Toddy's V2 file, but I've included the Fusion file in case it would need to be adjusted to fit that size.  The current hole size is 35mm.  

The holder has two corner holes to allow it to be tied in place on a rack or held on a wall with nails, screws or possibly eye hooks.  It uses 250g of filament due to its thickness, but I wanted to make sure there was plenty of surface area for gluing the two halves together.

In gratitude to ToddysTrinkets for allowing commercial use of this V1 sword handle I am uploading this file with the same license conditions. Toddy has some great other files; check them out!  Here is the link to the sword handle: https://makerworld.com/en/models/1306790-v1-kid-size-pool-noodle-sword-holes-19-25mm