Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
9 h
1 plate
Open in Bambu Studio
Boost
11
18
2
0
22
0
Released
Description
The crown of Yggdrasil extends over all worlds. Its upper branches reach to the roof of Valhalla.
Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm - print profile is in RAW files.
Filaments Used:
PLA Sunlu Black Transmission Distance: 0.3
PLA PM Green Transmission Distance: 5
PLA BambuLab Basic Gray Transmission Distance: 2
PLA Sunlu White Transmission Distance: 6
Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Green
At layer #15 (1.28mm) swap to Gray
At layer #19 (1.6mm) swap to White for the rest.
Comment & Rating (2)
All
Great print. Used the AMS. Swapped the fill pattern for Archimedean chords, otherwise the profile in the RAW is fabulous.
The designer has replied
1
Reply
Very nice! Thanks for the photo! :)
0
Reply
No more
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld