Compatible with (I think) all products using V4 Anchor Link System from Peak Design

Files

• peakDesignAirTagV2 [2024-02-01] - Recommended! Minor alterations to geometry around AirTag to allow easier insertion/removal. Still a very secure hold!
• peakDesignAirTag [2024-01-29]: Original file (shown in video). AirTag is difficult to insert and even more difficult to remove

Printing

Requires supports! I suggest 0.1mm layer height and PETG (or other robust material) for aesthetics and durability, respectively. It is fully functional at 0.2mm in PLA and PETG.

[Printables |Makerworld ]

Instructions

Thoroughly remove support material. The tolerances are tight and small remnants can interfere with the function of the clip. AirTag insertion requires quite a bit of force!

Notes

• Designed to allow full functionality of the PD Anchor Link System
• Tested on Cuff and the Anchors Links included with Everyday Backpack Zip
• Should work (but untested) with Leash & Slide camera straps, but NOT with Slide Lite as it has a wider base. I will consider supporting Slide Lite if there's interest!