purge deflector / poop deflector for A1 / A1 mini Remixed by dubios

Remixed by

dubios

3D Printer>3D Printer Accessories

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.16mm layer, 2 walls, 15% infill

Designer

21 min

1 plate

4.8(23)

Open in Bambu Studio

Boost

124

Released

Description

A purge deflector to flatter the design of the A1 series.

Print with 0.16 mm layer height, no support

Matching basket: https://makerworld.com/en/models/375011#profileId-274943

There is also a complete purge deflector basket system (mini pms) with this design: https://makerworld.com/en/models/131754#profileId-153965

Comment & Rating (36)

@user_2757694584

S'adapte parfaitement à l'imprimante Peut-être une variante avec une inscription ' A1 mini ' ?

The designer has replied

@dubios

Thanks! You can do this with Bambu Studio, you'll find some tutorials on YouTube for that. Hope this helps :)

@Zoe_2014

Print Profile

0.16mm layer, 2 walls, 15% infill

perfect

(Edited)

The designer has replied

@dubios

Thanks!

@lcs3dprint1

Print Profile

0.16mm layer, 2 walls, 15% infill

Fit perfectly the printer

The designer has replied

@dubios

Thanks, looks good!

@alessandr018

Print Profile

0.16mm layer, 2 walls, 15% infill

super practical!

The designer has replied

@dubios

Thank you!

@myung

Print Profile

0.16mm layer, 2 walls, 15% infill

it some times falls off. had to add some double sided tape.

The designer has replied

@dubios

Oh, I'm sorry, that wasn't supposed to happen. Are the two lugs on the holder locked in place?

@ne0g33k

Print Profile

0.16mm layer, 2 walls, 15% infill

(Edited)

The designer has replied

@dubios

Thanks for sharing, looks good! Yeah that feature is a little bit weird.

(Edited)

@MikePrintsNow

Boosted

this model gives me the start that i had when my 3D printing journey began in the bambulab community, because of that i am happy to say to boost you😄

(Edited)

The designer has replied

@dubios

Thank you!

@user_2097678733

Print Profile

0.16mm layer, 2 walls, 15% infill

Clean print works 99% of the time. However, once in a while, it would bounce the poop back onto the billboard and onto the print.

The designer has replied

@dubios

Thanks for the review! Sounds like you got a strong printer here :D

(Edited)

@user_2097678733

Replying to @dubios :

I think it’s like a bad basketball shot 😅

(Edited)

@Birkehue

Print Profile

0.16mm layer, 2 walls, 15% infill

Works well and snug like a bug

The designer has replied

@dubios

Haha nice, thanks!

@nucleosenator

Print Profile

0.16mm layer, 2 walls, 15% infill

wall Is very small ...... thicken the Walls to improve the resistance of the piece

The designer has replied

@dubios

Thank you for your feedback! I can understand if it bothers you that the prurge deflector is slightly bendy but I like the minimalist approach. Also, due to the print orientation, the purge deflector is stable enough for the intended use. However, if the slight stretchiness bothers you, you are welcome to create a remix :)

(Edited)