Lamp base on 3 neopixel rings.

hw needed:

neopixel ring (16,24,35 leds)

1 of each size. Diameters of rings used are as follows

→ 91mm, 71mm and 51mm and inner 73, 53 and 33mm

raspberry pi pico

Also arduino uno or similar controller wit same footprint will serve you well.

Led twinkle code from arduino ide can be used as startpoint to optimize your own lamp look and feel :)

Thin wires and soldering iron

And bit of patience and time … :)

2x M3x10mm screw

Transparent and dark filament of your choice

Print diffusers without infill, or feel free to experiment with infill patterns :)