An interpretation of Sunflowers by Van Gogh made for filament painting.

Quite happy with how this one turned out - the layering makes the flower petals really pop.

An updated, more colorful hueforge of Sunflowers is now available. Check it out here!

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
Generic Black, Dark Green, Brown, Orange, Yellow, White

Swap Instructions:
Start with Black
At layer #6 (0.56mm) swap to Dark Green
At layer #8 (0.72mm) swap to Brown
At layer #13 (1.12mm) swap to Orange
At layer #16 (1.36mm) swap to Yellow
At layer #24 (2mm) swap to White for the rest.
 

Two print profiles have been provided as 6 colors are used:

1. for use with 2 or more AMS units
2. for use with a single AMS unit

The only difference is that the single AMS profile has been set to swap back to slots 1 and slot 2 after printing from slot 4. A pause has been added before the end of the 4th color (orange) to allow for slots 1 and 2 to be changed from Black and Dark Green to Yellow and White respectively.

In summary the print order for the single AMS profile will be Slot 1 → Slot 2 → Slot 3 → Slot 4 → Slot 1 → Slot 2.

Folks that do not have an AMS or are using different printers will need to replace filament swaps in the slicer with pauses and manually change filament.

X and Y dimensions can be resized as needed to fit smaller or larger build areas. Z should not be changed or the color layering will not work.

Happy printing! Share your makes!