This is a remix of kabauter's “Dispenser for Tampons”. I just smoothed out the edges and closed the back. Also I made a lid for it. I also added 4 holes on the bottom for some rubber buffers (diameter: 10mm; depth: 1.4mm).

This is a dispenser for tampons. Made for diameters up to ca. 16mm and a length of 52mm.

Ideally the pieces roll down the ramp. Sometimes they can get stuck. A little shaking helps.

Dimensions:

• length: 105 mm
• width: 60 mm
• height: 120 mm

Printing Parameters

• layer height: 0.2mm
• line width: 0.42mm
• wall loops: 3
• infill density: 15%
• support: yes, for the opening for the tampons (as you can see in the pictures)

Feel free to upload your Makes!

Updates:

• 18.01.2024: I added V2 with a slightly steeper and longer slope. I hope this solves the problem with the tampons getting stuck. Unfortunately, I wasn't able to test this myself, so I would be happy about a review.