Bed cable holder - Lerdge IX

Bed cable holder - Lerdge IX

Boost
1
2
0

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 2 walls, 15% infill
0.2mm layer, 2 walls, 15% infill
9 min
1 plate

Boost
1
2
0
0
2
2
Released

Description

Originally, the cable wanders under the bed and given the heat that the bed gives off, I didn't like it, so I created a kind of leg, a support that keeps the cable straight and a little more away from the bed, to avoid risks due to the heat of the bed and electrical wires.

For my part, I printed it in PETG, I hope it will hold up over time, I recommend ASA which I think holds more heat than PETG (but I didn't have any, I did with what I had)

This tab replaces the original tab which holds the belt tight, so I replaced the original tab on my version and which attaches to the same place as the original one without alternating the operation of this one, we can so also tension the belt without too much problem during installation, I left a space for that.

Comment & Rating (0)

Please fill in your opinion
(0/5000)

No more