Baseboard Corner Protector

Description:

This 3D printable corner guard is designed to protect baseboards from damage, especially in high-traffic areas or where furniture might scuff them. Its simple, clean design blends seamlessly with most modern interiors.

Dimensions:

• Height: 100mm
• Depth: 14mm

Key Features:

• Protective: Shields baseboard corners from impacts, scuffs, and general wear and tear.
• Sleek Design: A minimalist profile that integrates well with existing baseboards without being obtrusive.
• Easy to Install: Can be attached using adhesive tape (e.g., double-sided foam tape) or a small amount of construction adhesive for a secure fit.
• Customizable: Can be printed in various colors to match your baseboards or wall color, or painted after printing.

Printing Recommendations (for Bambu Lab):

• Material: PETG or PLA are good choices. PETG offers more durability and impact resistance, while PLA is easier to print.
• Layer Height: 0.2mm for a good balance of detail and print time.
• Infill: 15-20% rectilinear or grid infill should be sufficient for structural integrity.
• Walls/Perimeters: 2-3 walls for added strength.
• Supports: Not typically required for this design, but check your slicer's preview.
• Brim/Raft: Not usually necessary, but can be added if you experience adhesion issues.

Installation:

1. Clean the baseboard corner surface thoroughly.
2. Apply double-sided foam tape to the back surfaces of the protector, or a small bead of construction adhesive.
3. Align the protector with the baseboard corner and press firmly into place.
4. Allow adhesive to cure if using.