Bambu Lab AMS Cardboard Spool ring - Eryone spool
Copyright Claim
Bambu Lab AMS Cardboard Spool ring - Eryone spool
Boost
187
287
191
Print Profile(4)
0.2mm layer, 2 walls, 15% infill
Designer
30 min
1 plate
0.2mm layer, 3 walls, 15% adaptive infill
24 min
1 plate
0.2mm layer, 6 walls, 100% infill
35 min
1 plate
0.2mm layer, 2 walls, 15% infill
26 min
1 plate
Boost
187
287
191
4
1.1 k
1.7 k
Released
Description
Cardboard spool adapter made to fit Eryone spools measuring 197mm.
Locating pegs top/bottom and the holes left open at the sides for clipping filament in.
Included 3mf file prints at 0.20 in around 25 mins. Print 2 per spool.
Comment & Rating (191)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
Fits great! May add a dab of superglue on it too to keep it on there for good.
The designer has replied
1
Reply
Hot glue also works well and comes off a touch easier when its time to move to another spool :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works perfect
2
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
it works fine!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Nice fit, still to see if it will fall off or not when in use. Worst case scenario, I'll attach it with thread through the holes.
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
fit!
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Well done, fit perfect.
(Edited)
1
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
passt sehr gut
1
Reply
Print Profile
0.2mm layer, 6 walls, 100% infill
great
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% adaptive infill
sehr gut 😁 wie die anderen leider zu locker, was an den Rollen liegt
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
leider zum teil zu locker, liegt aber eher an den Rollen 😁
0
Reply
License
This user content is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld