Mechanical Battery Dispenser Tower by KG3Dee

KG3Dee

Household>Office

GIF

Print Profile(1)

All

X1 Carbon

P1S

P1P

X1E

0.2mm layer, 3 walls, 15% infill

Designer

5.9 h

3 plates

4.5(49)

Open in Bambu Studio

Boost

326

570

700

433

Released

Description

Mechanical battery dispenser tower.

14.02.24 Update:

Added height for more capacity, as well as easing off some tolerances.

Holds up to 19x AA batteries.

Make sure all moving parts can move freely with no binds.

Comment & Rating (70)

@a.schmidt71

Print Profile

0.2mm layer, 3 walls, 15% infill

Ein sehr schönes, durchdachtes und einwandfrei funktionierendes Design. Danke für ihre Arbeit in das Projekt.

@urged

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

Works perfect!! Thanks

@rian4429

Print Profile

0.2mm layer, 3 walls, 15% infill

beautiful battery holder

@rian4429

good design

@savolab

Print Profile

0.2mm layer, 3 walls, 15% infill

really excellent, congratulations. Now I'm waiting for the one for the AAA batteries ;)

(Edited)

@KimKam

Great design and engineering. I appreciate it was split into plates for two-colour printing. Came out excellent.

@kurticus

Boosted

Print Profile

0.2mm layer, 3 walls, 15% infill

Works great. Just ease down the first battery and you are good to go dropping them in. Waiting for AAA version to come out.

@ntosdad

do you have a aaa battery one?

The designer has replied

@KG3Dee

Only AA for now.

@Manfredo32

Ich habe es für AAA verkleinert, jedoch den Durchmesser der Batterien nicht bedacht, jetzt fallen sie durch. :-(

@joeturczak

yeah I would like one for AAA batteries also.

@tjhallberg

Print Profile

0.2mm layer, 3 walls, 15% infill

No instructions, had to take it apart a few times to get everything together. tolerances are a bit tight, batteries get stuck and have to tap it on the table to get them out.

@joeturczak

there's a photo that helps with assembly in the product description.. it's hard to see because it's like 9 pictures in a collage instead of individually. but it helps a lot.

(Edited)

@PrkchpsNaplsaws

printed out just fine... but the parts don't fit together... was I supposed to change something ? x1 carbon

The designer has replied

@KG3Dee

No changes should be necessary. Not sure why that would be..

@joeturczak

I had a problem with one of the sorting locks being a bit hard to get on. all the rest of the parts were tight fitting. I printed mine on an A1 Mini. only trouble I see with it is the slot for the positive side of the batteries is a bit tight so maybe it'll get better with use, but I still have to give them a bit of a push down the slide sometimes.